Precise equipment: The precise equipment in the device includes gauges, sensors, keys and pressure switches, etc., which are responsible for protecting the device and its components.
Digital flowmeter: The digital flowmeter has the purpose of measuring the flow rate of production water, waste water or recycling in a unit of time.
TDS sensor: T sensor DS in the path of the purified outlet water, or the permit, is responsible for measuring the dissolved substances in the water, or the TDS and EC.
High pressure and low pressure: This piece before and after the pumps in order not to leave the pump out of the diagram and plays a protective role for the pump
Turbidity meter : Installing this part in the device gives us the assurance that the pre-treatments have done their work correctly or not.
High pressure pump: Boldly It can be said that after the membrane, the main and most important part is the high pressure pump of the device. Choosing the right water for this pump will make the device work better and prolong its life.
Gage: The mechanism of the RO device is based on pressure. Low pressure and high pressure are divided and also have different measurement units.
Raw water pump: The raw water pump, or in other words, the feed pump, is responsible for feeding and delivering suitable raw water both in terms of flow rate and pressure to the high pressure pump.
Command center: The center of the command or the power panel and power transmission. It is the location of PLC or ROC. which these two parts control the entire device.
Sampling valves: These valves are used to take samples from each pressure vessel separately and take samples from each The pressure vessel gives the operator the possibility to detect faults early.
Chassis of the water purifier: The chassis is the location of all the small and large components of an industrial water purifier. The material, type of connection and cover of the chassis is very important in its selection.
Inlet solenoid valve: One of the solenoid valves of the device is the inlet valve, which is responsible for It is the control of the incoming water to the water purifier.
Driver: We usually use the drivers in the electrical panel of the device to control and change the pump dynamo frequency and control it. The driver is more common in marine desalination plants.
Pressure vessel: The location of the membrane on the chassis and its connection to other components is done by the pressure vessel. Pressure vessels are divided depending on the working pressure of the device and the type of water entering them.